Cadillac Escalade: Automatic Fold and Tumble Feature - Second Row Seats - Rear Seats - Seats and Restraints - Cadillac Escalade Owner's ManualCadillac Escalade: Automatic Fold and Tumble Feature

The transmission must be in P (Park) for this feature to work.

WARNING WARNING

Automatically folding and tumbling the seat when someone is sitting in the seat, could cause injury to the person sitting there. Always make sure there is no one sitting in the seat before pressing the automatic seat release button.

Folding and Tumbling the Second Row Seat from the Third Row Seat or Outside the Vehicle

WARNING WARNING

Using the third row seating position while the second row is folded, or folded and tumbled, could cause injury in a sudden stop or crash. Be sure to return the seat to the passenger seating position. Push and pull on the seat to make sure it is locked into place.

To fold and tumble the seat from the third row seat, if equipped:

1. Make sure that there is nothing under, in front of, or on the seat.

Notice: Folding a rear seat with the safety belts still fastened may cause damage to the seat or the safety belts. Always unbuckle the safety belts and return them to their normal stowed position before folding a rear seat.

Driver Side Rear Panel Button Shown

Driver Side Rear Panel Button Shown

2. Press the automatic seat release button on the panel behind the rear doors.

The seatback automatically folds flat and the seat tumbles forward. There will be a slight delay between the folding of the seatback and the tumbling of the seat.

    Folding and Tumbling the Seat from the Third Row Seat
    WARNING Using the third row seating position while the second row is folded, or folded and tumbled, could cause injury in a sudden stop or crash. Be sure to return the seat to the passenger sea ...

    Returning the Seat to the Sitting Position
    To return the seat to the sitting position from the tumbled position: 1. Pull the seat down until it latches to the floor. The seatback cannot be raised if the seat is not latched to the floor. ...

    See also:

    Low-beam headlamps
    ► To switch on the low-beam headlamps: turn the SmartKey in the ignition lock to position 2 or start the engine. ► Turn the light switch to . The indicator lamp in the instru ...

    Front fog lamp bulb replacement
    1. Rotate the bulb holder (counter-clockwise) and remove from the lamp unit. 2. Press the two clips together, and remove the electrical connector. ...

    Getting Started on Your Route
    Once a destination has been entered, there are several functions that can be performed. Press DEST to access the Route screen. Turn List Press to view the list of turn maneuvers for the entire ...