Range Rover: Attaching the front towing eye
The front towing point is located behind a removable cover in the lower front bumper.
1. Rotate each of the fasteners 90 degrees counter-clockwise with a coin (or similar).
2. To remove the cover, lower the top edge and then pull the cover forward.
3. To refit, offer up the cover and ensure the two lugs at the bottom edge engage with the holes in the body panel.
4. Secure the cover in position by rotating each of the fasteners 90 degrees clockwise.
Off-road recovery
If the towing points are to be used for off-road recovery, it is essential that
off-road driver training covering recovery techniques is undertaken.
Further information on off-road driver training ...
Rear towing point
The rear towing point is located behind a removal panel in the lower rear bumper.
The rear towing point may be used to tow another vehicle if required.
1. Rotate each of the fasteners 90 degrees ...
See also:
Removing a wheel
► Unscrew the uppermost wheel bolt
completely.
► Screw alignment bolt 1 into the thread
instead of the wheel bolt.
► Unscrew the remaining wheel bolts fully.
Do not place wh ...
Opening/closing automatically fromoutside
Important safety notes
WARNING
Make sure the tailgate is closed when the
engine is running and while driving. Among
other dangers, deadly carbon monoxide (CO)
gases may enter vehicle ...
Vehicle identification plate withvehicle identification number (VIN)and paint code number
► Open the driver's door.
You will see vehicle identification plate 1.
Example: vehicle identification plate (USA only)
2 Paint code
3 VIN
Example: vehicle identification plate (Can ...
