Cadillac Escalade: Adding Washer Fluid
The vehicle has a low washer fluid message on the DIC that comes on when the washer fluid is low. The message is displayed for 15 seconds at the start of each ignition cycle. When the WASHER FLUID LOW ADD FLUID message displays, washer fluid will need to be added to the windshield washer fluid reservoir.

Open the cap with the washer symbol on it. Add washer fluid until the tank is full. See Engine Compartment Overview for reservoir location.
Notice
- When using concentrated washer fluid, follow the manufacturer's instructions for adding water.
- Do not mix water with ready-to-use washer fluid. Water can cause the solution to freeze and damage the washer fluid tank and other parts of the washer system.
- Fill the washer fluid tank only three-quarters full when it is very cold. This allows for fluid expansion if freezing occurs, which could damage the tank if it is completely full.
- Do not use engine coolant (antifreeze) in the windshield washer. It can damage the windshield washer system and paint.
What to Use
When windshield washer fluid needs to be added, be sure to read the manufacturer's
instructions before use. Use a fluid that has sufficient protection against freezing
in an area where the tempe ...
Brakes
This vehicle has disc brakes. Disc brake pads have built-in wear indicators that
make a high-pitched warning sound when the brake pads are worn and new pads are
needed. The sound can come and go or ...
See also:
Tire pressure label
The recommended tire pressures are listed on a label located in the driver’s
door opening. These pressures provide optimum ride and handling characteristics
for all normal operating conditions ...
Power Assist Steps
The vehicle may have power assist steps. To enable or disable the power assist
steps push .
The power assist steps automatically extend from beneath the vehicle on the side
in which the door has ...
Automatic climate control
Automatic operation
Cooling and/or dehumidified heating
(AUTO):
This mode may be used all year round. The
system works automatically to control the
inside temperature, air flow distribution
...






