Mercedes-Benz GL-Class: Activating/deactivating airrecirculation mode
You can deactivate the flow of fresh air if unpleasant odors are entering the vehicle from outside. The air already inside the vehicle will then be recirculated.
The operation of air-recirculation mode is the same for all control panels.
WARNING
Fogged windows impair visibility,
endangering you and others. If the windows
begin to fog on the inside, switching off the
air recirculation mode immediately should
clear interior window fogging. If interior
window fogging persists, make sure the air
conditioning is activated, or press the
button.
► Turn the SmartKey to position 2 in the
ignition lock.
► To activate: press the
button.
The indicator lamp in the button
lights
up.
Air-recirculation mode is activated
automatically at high outside
temperatures. When air-recirculation mode
is activated automatically, the indicator
lamp in the
button is not lit.
Outside air is added after about 30 minutes.
► To switch off: press the
button.
The indicator lamp in the button
goes
out.
Air-recirculation mode deactivates
automatically:
• after approximately five minutes if
outside temperatures are less than about
41 °F (5 °C)
• after approximately five minutes if
cooling with air dehumidification is
deactivated
• after approximately 30 minutes if outside
temperatures are over about
41 °F (5 °C)
The air-recirculation mode is not
deactivated automatically at outside
temperatures above 79 °F (26 °C). After
approximately 30 minutes, outside air is
added.
Rear window defroster
Activating/deactivating
WARNING
Any accumulation of snow and ice should be
removed from the rear window before driving.
Visibility could otherwise be impaired,
endangering you and o ...
Activating/deactivating the residualheat function
It is possible to make use of the residual heat
of the engine to continue heating the
stationary vehicle for up to 30 minutes after
the engine has been switched off. The heating
time depends on th ...
See also:
Programming HomeLink® for Canadian customers
Prior to 1992, D.O.C. regulations required
hand-held transmitters to stop transmitting
after 2 seconds. To program your handheld
transmitter to HomeLink®, continue to
push and hold the HomeLi ...
Multifunction steering wheel
1 Multifunction display
2 COMAND; see the separate
operating instructions
3 Rejects or ends a call
Exits phone book/redial memory
Makes or accepts a call
Switches to the redial
mem ...
How to Check Lubricant
To get an accurate reading, the vehicle should be on a level surface.
A. Drain Plug
B. Fill Plug
If the level is below the bottom of the fill plug hole, located on the transfer
case, some lubric ...