Cadillac Escalade: Using Your Stored Preset Destinations - Overview - Introduction - Infotainment System - Cadillac Escalade Owner's ManualCadillac Escalade: Using Your Stored Preset Destinations

These destinations are available for selection while driving.

1. Press 2. A caution may appear. Press OK to proceed. to turn the system on.

2. A caution may appear. Press OK to proceed.

3. Press DEST.

4. Select one of the available preset destination screen buttons. A map screen, with the destination marked appears.

5. Select the route preference for Fastest, Shortest, or Other. The system calculates and highlights the route.

6. Press Start Guidance. The route is now ready to be started.

See “Preset Destination” under Destination   for more information.

    Entering an Address and Point of Interest, and Storing Preset Destinations
    Entering an Address Enter a destination by inputting the city name first: 1. Press O to turn the system on. 2. A caution may appear. Press OK to proceed. 3. Press DEST. 4. Press2(Address Entry). ...

    Canceling Guidance
    Guidance is canceled once the final destination is reached. To cancel guidance prior to arrival at the final destination: 1. Press DEST. 2. Press Cancel Guidance. 3. Press OK to confirm. Guidance ...

    See also:

    Storing the Tire Sealant and Compressor Kit
    The tire sealant and compressor kit is located in the storage compartment on the driver side, at the rear of the vehicle. 1. Press down on the latch tab and pull the cover off to access the stora ...

    Windshield Wiper/Washer
    The front and rear wiper controls are located on the turn and lane-change lever. Turn the band with the wiper symbol to control the windshield wipers. : For a single wipe, turn to , then release. ...

    Ultrasonic Parking Assist
    If available, the Ultrasonic Rear Parking Assist (URPA) system uses sensors on the rear bumper to assist with parking and avoiding objects while in R (Reverse). WARNING The URPA system does not ...