Range Rover: Tool kit - Wheel changing - Range Rover Owner's ManualRange Rover: Tool kit

Note: Tool types and positions may vary from the illustrations.

The tool kit is located under a panel set in the loadspace floor.

The tool kit is located under a panel set in the loadspace floor.

Note: Take careful note of the stowage position for each tool, as it is important to return them to their correct position after use.

    Wheel changing safety
    Before raising the vehicle or changing a wheel, ensure that you read and comply with the following warnings. WARNING Always find a safe place to stop, off the highway and away from traffic. ...

    Removing the spare wheel
    WARNING Remove the spare wheel prior to jacking the vehicle, to avoid destabilizing the vehicle when raised. The spare wheel is heavy and if handled incorrectly may cause injury. Use extreme ...

    See also:

    Compass
    Your vehicle may have a compass in the Driver Information Center (DIC). Compass Zone The zone is set to zone eight upon leaving the factory. Your dealer will set the correct zone for your location. ...

    Exterior rear
    1. Fuel-filler door (P.3-23) — Fuel recommendation (P.9-4) 2. Antenna (P.4-80) 3. Rear combination light (bulb replacement) (P.8-27) 4. Rear window defroster (P.2-36) 5. Satellite ante ...

    Engine compartment check locations
    VK56VD ENGINE MODEL 1. Window washer fluid reservoir 2. Fuse/fusible link holder 3. Engine oil dipstick 4. Power steering fluid reservoir 5. Engine oil filler cap 6. Brake fluid reservoir ...