Infiniti QX: Temperature A, B and C
The temperature grades A (the highest), B, and C, representing the tire’s resistance to the generation of heat and its ability to dissipate heat when tested under controlled conditions on a specified indoor laboratory test wheel. Sustained high temperature can cause the material of the tire to degenerate and reduce tire life, and excessive temperature can lead to sudden tire failure. The grade C corresponds to a level of performance which all passenger car tires must meet under the Federal Motor Vehicle Safety Standard No. 109. Grades B and A represent higher levels of performance on the laboratory test wheel than the minimum required by law.
WARNING
The temperature grade for this tire is
established for a tire that is properly
inflated and not overloaded. Excessive
speed, under-inflation, or excessive loading,
either separately or in combination, can
cause heat build-up and possible tire failure.
Traction AA, A, B and C
The traction grades, from highest to lowest,
are AA, A, B and C. Those grades
represent the tire’s ability to stop on wet
pavement as measured under controlled
conditions on specified govern ...
Emission control system warranty
Your INFINITI is covered by the following
emission warranties.
For USA:
► Emission Defects Warranty
► Emissions Performance Warranty
Details of these warranties may be found
with o ...
See also:
Road testing dynamometers (rolling roads)
It is essential that any dynamometer testing is carried out only by a qualified
person, familiar with the dynamometer testing and safety procedures practiced by
Land Rover Retailer/ Authorized Rep ...
4MATIC (permanent four-wheel drive)
4MATIC ensures that all four wheels are
permanently driven. Together with ESP® and
4ETS, it improves the traction of your vehicle
whenever a drive wheel spins due to
insufficient grip.
WARNING&n ...
Shuffle Functionality
To use Shuffle:
Press the softkey below,
or
to select between Shuffle Off, Shuffle
All Songs/ Shuffle Songs, Shuffle Album, or Shuffle Folder.
(Shuffle Off): This is the default
mode when a ...






