Range Rover: Switching off the engine - Starting the engine - Range Rover Owner's ManualRange Rover: Switching off the engine

Before stopping the engine, ensure that the vehicle is parked safely with the parking brake applied and P selected.

Press and release the engine START/STOP button to stop the engine. The audio, telephone and touch screen systems will revert to stand-by mode.

Pressing the START/STOP button again (without pressing the brake pedal), will activate the systems.

Switching off the engine while the vehicle is moving:

NOTICE NOTICE

It is not advisable to switch off the engine while the vehicle is moving. However, if a situation arises where engine switch off is urgent, the following procedure applies:

1. Press and hold the START/STOP button for 2 seconds, or

2. Press and release the START/STOP button twice within 2 seconds.

With either method, the warning message Engine Stop Button Pressed will be displayed.

    If the engine fails to start
    If the vehicle has been unlocked using the emergency key blade or the Smart Key is not detected by the vehicle, it will be necessary to use the keyless start backup to disarm the alarm and start t ...

    Rolling re-start
    A rolling restart can be initiated by selecting N (neutral) and pressing the engine START/STOP button. ...

    See also:

    Glass Replacement
    If the windshield or front side glass must be replaced, see your dealer to determine the correct replacement glass. ...

    Lumbar Adjustment
    To adjust the lumbar support: Press and hold the front or rear of the control to increase or decrease lumbar support. Press and hold the top or bottom of the control to raise or lower the ...

    Tail lamps with LEDs
    1 Rear fog lamp 2 Backup lamp ► Switch off the lights. ► Open the cargo compartment. ► Open the side trim panel. ► Turn the corresponding bulb holder counter-clockwise ...