Mercedes-Benz GL-Class: Storing the current speed or calling upthe last stored speed - DISTRONIC - Driving systems - Driving and parking - Mercedes-Benz GL-Class Owner's ManualMercedes-Benz GL-Class: Storing the current speed or calling upthe last stored speed

Mercedes-Benz GL-Class / Mercedes-Benz GL-Class Owner's Manual / Driving and parking / Driving systems / DISTRONIC / Storing the current speed or calling upthe last stored speed

WARNING The set speed stored in memory should only 
The set speed stored in memory should only be set again if prevailing road conditions and legal speed limits permit. Possible acceleration or deceleration differences arising from returning to the preset speed could cause an accident and/or serious injury to you and others.

► Briefly pull the cruise control lever towards you 4.

► Remove your foot from the accelerator pedal.

DISTRONIC is activated and accepts the current speed if it is activated for the first time, or adjusts the vehicle's speed to the last speed stored.

    Making adjustments in 5 mph (Canada:10 km/h) increments
    ► Briefly press the cruise control lever beyond the pressure point, up 1 for a higher speed or down 2 for a lower speed. The last speed stored is increased or reduced. ...

    Setting the specified minimum distance
    You can set the specified minimum distance for DISTRONIC by varying the time span between one and two seconds. This time span determines the distance that DISTRONIC should maintain from the vehicl ...

    See also:

    Tire Sealant and Compressor Kit
    WARNING Idling a vehicle in an enclosed area with poor ventilation is dangerous. Engine exhaust may enter the vehicle. Engine exhaust contains carbon monoxide (CO) which cannot be seen or smelled ...

    Radio Frequency Identification (RFID)
    RFID technology is used in some vehicles for functions such as tire pressure monitoring and ignition system security, as well as in connection with conveniences such as key fobs for remote door lo ...

    Operating tips
    ► The images from a device that is connected to the rear auxiliary input jacks cannot be viewed on the front displays. ► It is not possible to switch the source to USB (if so equ ...