Mercedes-Benz GL-Class: Other bulbs
There are bulbs other than the Xenon bulbs that you cannot replace. Replace only the bulbs listed. Have the bulbs that you cannot replace yourself changed at a qualified specialist workshop.
Mercedes-Benz recommends that you use an authorized Mercedes-Benz Center for this purpose. In particular, work relevant to safety or on safety-related systems must be carried out at a qualified specialist workshop.
If you require assistance changing bulbs, consult a qualified specialist workshop.
Do not touch the glass tube of new bulbs with your bare hands. Even minor contamination can burn into the glass surface and reduce the service life of the bulbs. Always use a lintfree cloth or only touch the base of the bulb when installing.
Only use bulbs of the correct type.
If the new bulb still does not light up, consult a qualified specialist workshop.
Bulbs and lamps are an important aspect of vehicle safety. You must therefore make sure that these function correctly at all times.
Have the headlamp setting checked regularly.
WARNING
Bulbs and lamps can be very hot. You should
therefore allow them to cool down before you
change them. Otherwise, you could be burned
if you touch them.
Keep bulbs out of the reach of children.
Otherwise, they could damage the bulbs, for
example, and injure themselves.
Never use a bulb which has been dropped.
Such a bulb may break or even explode and
injure you.
Halogen bulbs are pressurized and can
explode when you change them, particularly
if they are very hot. You should therefore wear
eye protection and gloves when you are
changing them.
Xenon bulbs
If your vehicle is equipped with Xenon bulbs,
you can recognize this by the following: the
cone of light from the Xenon bulbs moves
from the top to the bottom and back again
when you start the eng ...
Overview: changing bulbs/bulb types
You can change the following bulbs. The bulb
type can be found in the legend.
Halogen headlamps
1 Low-beam headlamp: H7 55 W
2 High-beam headlamp: H7 55 W
3 Parking lamp/standing lamp: W 5 W
4 ...
See also:
Trip computer
Switches for the trip computer are located
on the right side of the combination meter
panel. To operate the trip computer, push
the switches as shown above.
When the ignition switch is push ...
Stowing the changed wheel
WARNING
Do not stow the wheel while the vehicle is raised on the jack.
NOTICE
Do not use power tools to raise the spare wheel. Doing so may damage the mechanism.
1. Place the wheel und ...
Automatic door locks
► All doors lock automatically when the
vehicle speed reaches 15 MPH (24
km/h).
► All doors unlock automatically when the
ignition switch is placed in the OFF
position.
The aut ...






