Mercedes-Benz GL-Class: Opening/closing the garage door
Once programmed, the integrated garage door opener will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.
► Turn the SmartKey to position 2 in the
ignition lock.
► Press transmitter button 2, 3 or 4 in the
overhead control panel that you have
programmed to operate the garage door.
Garage door system with a fixed code:
indicator lamp 1 lights up green.
Garage door system with a rolling code:
indicator lamp 1 flashes green.
The transmitter will transmit a signal for
as long as the transmitter button is being
pressed. After a maximum of ten seconds,
transmission is terminated and indicator
lamp 1 flashes yellow. Press the
transmitter button again, if necessary.
Programming the integrated garagedoor opener on the rear-view mirror
Programming
WARNING
Only press the transmitter button on the
integrated garage door opener if there are no
persons or objects present within the sweep
of the garage door. People could ...
Clearing the memory of the integratedgarage door opener on the rear-viewmirror
► Turn the SmartKey to position 2 in the
ignition lock.
► Press transmitter buttons 2 and 4.
The indicator lamp lights up yellow.
► Press and hold transmitter buttons 2 and 4 ...
See also:
SBZA Detection Zones
The SBZA sensor covers a zone of approximately one lane over from both sides
of the vehicle, 3.5m (11 ft). This zone starts at each side mirror and goes back
approximately 5.0m(16 ft). The height ...
Driving in Water
WARNING
Driving through rushing water can be dangerous. Deep water can sweep your vehicle
downstream and you and your passengers could drown. If it is only shallow water,
it can still wash away ...
Automatic Operation
AUTO (Automatic): When automatic operation is active the system will control
the inside temperature, the air delivery, and the fan speed.
Use the steps below to place the entire system in automatic ...