Infiniti QX: Loading tips - Vehicle loading information - Technical and consumer information - Infiniti QX Owner's ManualInfiniti QX: Loading tips

► The GVW must not exceed GVWR or GAWR as specified on the F.M.V. S.S./C.M.V.S.S. certification label.
► Do not load the front and rear axle to the GAWR. Doing so will exceed the GVWR.

► Properly secure all cargo to help WARNING

► Properly secure all cargo to help prevent it from sliding or shifting. Do not place cargo higher than the seatbacks. In a sudden stop or collision, unsecured cargo could cause personal injury.
► Do not load your vehicle any heavier than the GVWR or the maximum front and rear GAWRs. If you do, parts of your vehicle can break, tire damage could occur, or it can change the way your vehicle handles. This could result in loss of control and cause personal injury.
► Overloading not only can shorten the life of your vehicle and the tire, but can cause unsafe vehicle handling and long braking distance. This may cause a premature tire failure, which could result in a serious accident and personal injury. Failures caused by overloading are not covered by the vehicle’s warranty.

    Securing the load
    There are tie down hooks located in the cargo area as shown. The tie down hooks can be used to secure cargo with ropes or other types of straps. Do not apply a total load of more than 22 lb ...

    Measurement of weights
    Secure loose items to prevent weight shifts that could affect the balance of your vehicle. When the vehicle is loaded, drive to a scale and weigh the front and the rear wheels separately to ...

    See also:

    Opening and closing windows with the mechanical key
    The driver’s door key operation also allows you to open and close all door windows. To open the windows, turn the driver’s door key cylinder to the rear of the vehicle for longer than 1 se ...

    TEHAMAâ„¢ Leather
    The leather surface on the seat was not designed to be aggressively cleaned using any commercial product. Use a well wrung cloth dampened with water to remove dust. Do not use a wet cloth or saturat ...

    Before programing
    NOTICE When programing a device that may require you to press and re-press the hand-held transmitter (cycle), unplug the device during the cycling process to prevent possible motor failure. ...