Infiniti QX: Hood - Pre-driving checks and adjustments - Infiniti QX Owner's ManualInfiniti QX: Hood

1. Pull the hood lock release handle 1

1. Pull the hood lock release handle 1 located below the instrument panel; the hood will then spring up slightly. 2. Pull the lever 2 up at the front of the hood with your fingertips and raise the hood. 3. When closing the hood, slowly close the hood down and make sure it locks into place.

► Make sure the hood is completely closed WARNING

► Make sure the hood is completely closed and latched before driving. Failure to do so could cause the hood to fly open and result in an accident.
► If you see steam or smoke coming from the engine compartment, to avoid injury do not open the hood.

    Remote keyless entry system
    WARNING The Intelligent Key transmits radio waves when the buttons are pushed. The FAA advises that radio waves may affect aircraft navigation and communication systems. Do not operate the ...

    Lift gate
    WARNING ► Always be sure the lift gate has been closed securely to prevent it from opening while driving. ► Do not drive with the lift gate open. This could allow dangerous exha ...

    See also:

    Clearing the programmed information
    Individual buttons cannot be cleared, however to clear all programming, push and hold the two outside buttons and release when the indicator light begins to flash (in approximately 20 seconds) ...

    Activating the rear view camera
    ► Make sure that the SmartKey is in position 2 in the ignition lock. ► Make sure that the "rear view camera" function is selected in COMAND (see the separate operating inst ...

    Towing load/specification
    1: The towing capacity values are calculated assuming a base vehicle with driver and any options required to achieve the rating. Additional passengers, cargo and/or optional equipment will add ...