Infiniti QX: Entry/exit function - Automatic drive positioner - Pre-driving checks and adjustments - Infiniti QX Owner's ManualInfiniti QX: Entry/exit function

This system is designed so that the driver’s seat and steering column will automatically move when the automatic transmission selector lever is in the P (Park) position. This allows the driver to get into and out of the driver’s seat more easily. The driver’s seat will slide backward and the steering wheel will move up when the driver’s door is opened with the ignition switch in the LOCK position. The driver’s seat and steering wheel will return to the previous positions when the ignition switch is pushed to the ACC position. The driver’s seat will not return to the previous positions if the seat or steering adjusting switch is operated when the seat is at the exit position.

Cancel or activate entry/exit function

The selector lever must be in the P (Park) position with the ignition switch in the OFF position. The entry/exit function can be activated or canceled by pressing and holding the SET switch for more than 10 seconds. The indicator lights on the memory switches (1 and 2) will blink once when the function is canceled, and the indicator lights will blink twice when the function is activated. Note that the indicator lights may illuminate after 5 seconds while holding the SET switch. This indicates readiness for linking the Intelligent Key to a stored memory position. Keep the SET AUTOMATIC DRIVE POSITIONER switch pressed for more than 10 seconds to turn on or off the entry/exit function. The entry/exit function can also be activated or canceled if the “Lift Steering Wheel on Exit” key or “Slide Driver Seat Back on Exit” key is turned to ON or OFF in the “Comfort” settings. (See “Vehicle information and settings” in the “4. Monitor, climate, audio, phone and voice recognition systems” section.)

Initialize entry/exit function

If the battery cable is disconnected, or if the fuse opens, the entry/exit function will not work though this function was set on before. In such a case, after connecting the battery or replacing with a new fuse, open and close the driver’s door more than two times after the ignition switch is turned from the ON position to the LOCK position. The entry/exit function will be activated.

    Automatic drive positioner
    SET/memory switches The automatic drive positioner system has three features: ► Entry/exit function► Memory storage► Setting memory function ...

    Memory storage
    Two positions for the driver’s seat, steering column and outside mirrors can be stored in the automatic drive positioner memory. Follow these procedures to use the memory system. 1. Move t ...

    See also:

    MP3 Format
    There are guidelines that must be met, when creating an MP3 disc. If the guidelines are not met when recording a CD-R(W), the CD may not play. The guidelines are: Sampling rate: 16 kHz, 22.05 kHz ...

    Engaging the differential locks
    Pull away slowly when the differential locks are activated. Function or performance tests may only be performed on a 2-axle dynamometer. If you wish to operate the vehicle on such a dynamomet ...

    Connecting procedure
    1. Push the button, and select the “Connect Phone” key. 2. When a PIN code appears on the screen, operate the compatible Bluetooth ® cellular phone to enter the PIN code. The co ...