Cadillac Escalade: Easy Exit Positions
This feature can move the driver seat rearward and the power steering column up and forward to allow extra room to exit the vehicle.
(Easy Exit Positions): Press to recall
the easy exit positions. The vehicle must be in P (Park).
If the easy exit feature is programmed on in the vehicle personalization menu, automatic driver seat and power steering column movement occur when the ignition key is removed.
A single beep sounds. The driver seat moves back approximately 8 cm (3 in) and
the power steering column moves up and forward. To move the seat back farther, press
again until the seat is all the way
back.
If something has blocked the driver seat while recalling the exit position, the recall may stop. Remove the obstruction; then press and hold the power seat control rearward for two seconds. Try recalling the exit position again. If the exit position is still not recalling, see your dealer for service.
See Vehicle Personalization .
Memory Remote Recall
The memory feature can recall the driver seat, outside mirrors, power steering
column, and pedals to stored positions when entering the vehicle.
To activate, unlock the driver door with the Remote K ...
Heated and Ventilated Front Seats
WARNING
If you cannot feel temperature change or pain to the skin, the seat heater may
cause burns even at low temperatures. To reduce the risk of burns, people with such
a condition should use ...
See also:
Self-adjusting brakes
Your vehicle is equipped with self-adjusting
brakes.
The disc-type brakes self-adjust every time
the brake pedal is applied.
WARNING
See an INFINITI retailer for a brake system
check if th ...
Please bear the following in mind
The engine oils are matched to the
performance of Mercedes-Benz engines and
service intervals. You should therefore only
use engine oils and oil filters that are
approved for vehicles with mainten ...
DEF
Important safety notes
For BlueTEC vehicles only.
DEF is a non-flammable, non-toxic, colorless,
odorless and water-soluble fluid.
Only use DEF that complies with
ISO 22241. Do not add any ...






