Mercedes-Benz GL-Class: Daytime running lamps
Daytime running lamps in Canada
The "daytime running lamps" function is required by law in Canada. It cannot therefore be deactivated.
► Turn the light switch to
.
With the engine running: depending on the ambient light, the daytime running lamps or the low-beam headlamps are switched on.
When the low-beam headlamps are
activated, the indicator lamp on
the
light switch and the
indicator lamp
in
the instrument cluster light up.
When the engine is running and the vehicle is stationary or if the parking brake is applied: if you move the selector lever from a drive position to P, the daytime running lamps/ low-beam headlamps go out after three minutes.
When the engine is running, the vehicle is
stationary and in high ambient light
brightness: if you turn the light switch
to , the daytime running lamps and
the
parking lamps are switched on.
Daytime running lamps in the USA
In the USA, the daytime running lamps are deactivated upon delivery from the factory.
► To activate the daytime running lamps: activate the daytime running lamps function in the on-board computer.
► Turn the light switch to
.
With the engine running: depending on the ambient light, the daytime running lamps or the low-beam headlamps are switched on.
When the low-beam headlamps are
activated, the indicator lamp on
the
light switch and the
indicator lamp
in
the instrument cluster light up.
If the engine is running and you turn the light
switch to or
, the manual settings
take precedence over the daytime running
lamps.
Low-beam headlamps
► To switch on the low-beam headlamps:
turn the SmartKey in the ignition lock to
position 2 or start the engine.
► Turn the light switch to
.
The indicator lamp in the
instru ...
Automatic headlamp mode
► To switch on automatic headlamp
mode: turn the light switch to .
SmartKey in position 1 in the ignition lock:
the parking lamps are switched on or off
automatically depending on the br ...
See also:
Drive-away locking
Drive-away locking automatically locks all the doors when the vehicle is in motion.
This feature can be enabled/disabled via the Vehicle Set-up menu (see 55, INTERACTIVE
CONTROLS.
Note: Pressing ...
Xenon lamps
WARNING
High voltage is required to ignite the gas and metal vapor which are used to
power Xenon lamps. Contact with this voltage can cause serious injury. Replacement
or maintenance of Xeno ...
System fault
If a fault is detected in the HDC system, HDC FAULT SYSTEM NOT AVAILABLE will
appear in the message center.
If the fault is detected while the system is operating, HDC assistance will fade
out.
...