Infiniti QX: Brake fluid
For further brake fluid specification information, see “Capacities and recommended fuel/lubricants” in the “9. Technical and consumer information” section of this manual.
WARNING
► Use only new fluid from a sealed
container. Old, inferior or contaminated
fluid may damage the brake system. The
use of improper fluids can damage the
brake system and affect the vehicle’s
stopping ability.
► Be sure to clean the filler cap before
removing.
► Brake fluid is poisonous and should be
stored carefully in marked containers out
of the reach of children.
CAUTION
► Do not add brake fluid with the ignition
switch in the “ON” position or the
engine running. Doing so could make
the brake fluid overfill when the ignition
switch is turned off.
► Do not spill the fluid on painted
surfaces. This will damage the paint. If
fluid is spilled, wash the surface with
water.
Brake fluid

Check the fluid level in the reservoir. If the fluid is below the MIN line1 or the brake warning light comes on, add Genuine NISSAN Super Heavy Duty Brake Fluid or equivalent DOT 3 fluid up to the MAX line 2 . To add brake fluid: 1. Be sure the ignition switch is in the OFF or LOCK position. 2. Depress and release the foot brake pedal more than 40 times. 3. Open the reservoir filler cap and add brake fluid up to the MAX line2 . (See “Capacities and recommended fuel/ lubricants” in the “9. Technical and consumer information” section for the recommended types of brake fluid.)
NOTE:
When the ignition switch is placed in the “ON” position after adding brake fluid up to the MAX line 2 in the reservoir, the brake fluid decreases below the MAX line 2 . This is normal. If fluid must be added frequently, the system should be checked by an INFINITI retailer.
Power steering fluid
Check the fluid level in the reservoir.
The fluid level should be checked using the
HOT range (1 : HOT MAX., 2 : HOT MIN.).
at fluid temperatures of 122 to 1768F (50
to 808C) or using the CO ...
Window washer fluid
WARNING
Antifreeze is poisonous and should be
stored carefully in marked containers out
of the reach of children.
Fill the window washer fluid reservoir
periodically. Add window washer flu ...
See also:
Auto closure
If the lift gate is pulled down to a partly
open position, the lift gate will pull itself to
the closed position.
Do not apply excessive force when the
auto closure is operating. Excessive for ...
TIREFIT kit version 1
► Open flap 2.
► Pull connector 5 with the cable and hose
6 out of the housing.
► Screw hose 6 onto flange 7 of tire
sealant bottle 1.
► Insert tire sealant bottle : hea ...
How to Check Lubricant
To get an accurate reading, the vehicle should be on a level surface.
A. Drain Plug
B. Fill Plug
If the level is below the bottom of the fill plug hole, located on the transfer
case, some lubric ...






