Buick Enclave: Anti-theft Alarm System - Vehicle Security - Keys, Doors, and Windows - Buick Enclave Owner's ManualBuick Enclave: Anti-theft Alarm System

On vehicles with an anti-theft alarm system, to activate the system:

► Press (RKE) transmitter or the power door lock switch when any door is open. on the Remote Keyless Entry (RKE) transmitter or the power door lock switch when any door is open.

The security light flashes.

The security light flashes.

When the door is closed, the security light stops flashing and stays on solid for approximately 30 seconds.

The content theft-deterrent alarm is not armed until the security light goes off.

If the delayed locking feature is active, the alarm is not activated until all doors are closed and the security light goes off.

► Press The security light comes on solid for approximately 30 seconds and then goes off. when the driver door is closed. The security light comes on solid for approximately 30 seconds and then goes off.

The content theft-deterrent alarm is not armed until the security light goes off.

The theft-deterrent system will not activate if the doors are locked with the vehicle's key or the manual door lock.

If a locked door is opened without using the RKE transmitter, a 10-second pre-alarm occurs.

The horn chirps and the lights flash.

If the key is not placed in the ignition and turned to START or the door is not unlocked by pressing pre-alarm, the alarm goes off. during the 10-second pre-alarm, the alarm goes off.

The headlamps flash and the horn sounds for about 30 seconds, then turns off to save the battery power.

The vehicle can be started with the correct ignition key if the alarm has been set off.

To avoid setting off the alarm by accident:

► Lock the vehicle with the door key after the doors are closed.

► Unlock the door with the RKE transmitter. Unlocking a door any other way sets off the alarm if the system has been armed.

Press and turn it to START to turn off the alarm. or place the key in the ignition and turn it to START to turn off the alarm.

Testing the Alarm

To test the alarm:

1. From inside the vehicle, lower the driver side window, and open the driver door.

2. Press 3. Get out of the vehicle, close the door, and wait for the security light to go.
3. Get out of the vehicle, close the door, and wait for the security light to go out.
4. Reach in through the window, unlock the door with the manual door lock, and open the door.

This should set off the alarm.

If the alarm does not sound when it should, but the headlamps flash, check to see if the horn works.

The horn fuse may be blown.

To replace the fuse, see Fuses and Circuit Breakers .

If the alarm does not sound or the headlamps do not flash, see your dealer for service.

    Vehicle Security
    This vehicle has theft-deterrent features; however, they do not make it impossible to steal. ...

    Immobilizer
    See Radio Frequency Statement  for information regarding Part 15 of the Federal Communications Commission (FCC) rules and Industry Canada Standards RSS-GEN/210/220/310. ...

    See also:

    Checking Engine Oil
    It is a good idea to check the engine oil level at each fuel fill. In order to get an accurate reading, the vehicle must be on level ground. The engine oil dipstick handle is a yellow loop. See Engi ...

    Last 10 option
    Allows view of the last 10 calls made, received or missed. Note: The vehicle will display the list in the order the calls were recorded. If this information is not available, they will be displayed ...

    DVD Menu Options
    Options: Press to view the menu option screen buttons. Menu options are available when they are highlighted. Some menu options are only available when the DVD is not playing. Cursor: Press to acces ...